Brakes

[Mall Crawler]

Ok so my junk was broke down for months and now i re did the rear axle and now i re installed my brake lines and shtuff and now i bleed them and they are ok for a little while and then the pedel goes to the floor and brake light comes on?

Whats up wit dat?

[Kev]

make sure the wheel cyl's aren't leaking. if not check for air again if no air i would suspect the master cyl. the light means that you have lost pressure in the system

[Mall Crawler]

Ok thanks

[Mall Crawler]

Whats the best way to bleed I always just pupmp em u and open the bleeder for a second and close it

[Arnold]

Get one of those 1-man brake bleeding tools from an auto parts store. They're cheap, easy to use and have always worked for me. I also have a Mityvac hand pump made for bleeding brakes and I still prefer/use the cheap brake bleeding too.:)

[Kev]

or 2 people, open bleeder push pedal down close bleeder coulpe times then see what you have by pumping them up but dont pump fast you can airiate the fluid just an easy pumping up.

[Not-Jobless]

Besides the wheel cylinders, re-check all the brake line fittings for any wetness, it only takes a small leak to go from good brakes to no brakes.