fubar cj
08-20-2006, 08:31 PM
FOR SALE: 1968 CJ5 project Jeep (sell complete or part out)
Buick 225 V6 with wide ratio T-19 (6.32=1 first gear) and Scout 300 TC
New bearings and seals in Trans and TC
New clutch, throw-out bearing.
Fly wheel resurfaced
Hydraulic clutch (all together and ready to go)
Dana 44 high pinion front differential 5:38 gears
ARB locker
Warn axle shafts and 2 spare 19 spline hubs and dial
New bearings, gears, locker, spindles, Warn hubs. 5 on 5-1/2 never been run
Dana 60 low pinion rear differential 5:38 gears
Detriot locker
35 spline flanged axles, new gears, etc. (never been run)
5 on 5-1/2 bolt pattern (needs brakes.) Both diffs are 58” wide
Floor pan replaced in tub
Custom frame 2x4x1/4 wall tubing (made to factory dimensions)
Misc. Parts:
T-19 close ratio trans. 4:1 first gear with Dana 18 TC and Warn OD
5 quanity Super Swamper TSL bias ply 36x12-1/2x15 tires mounted on steel wheels
Rubicon Express ¼ elliptical rear springs
Rubicon Express spring over springs (both new)
MTS under seat plastic fuel tank
Borgenson steering shaft, tilt steering column
Offset ’70-’71 Dana 44 rear differential housing with 30 spline flanged axles have 5:38 RP and carrier. New brakes
Warn full float kits for offset 44 complete with lock-out hubs and spare 30 spline hub
Standard rear seat (black)
’75 CJ gas tank
Rear tire carrier and Jerry can holder
2 quanity ’68 CJ5 heater assemblies. One works, the other one might?
Mechanical gauges (oil, water, temp, vacuum, gas, volts speedo, tach. SW, VDO, and autometer)
York AC compressor
Warn 8274 winch
Wind shield frame (glass good, wipers work, frame is rusty)
2 quanity tailgates
4 quanity 15x10 aluminum rims 3-1/4 back spacing
’68 Grille (good shape with lights and Rad)
’74 Grille (good shape)
Bikini top and half doors
2 quanity full doors
6-point roll cage and competition seat belts 3” wide
Buick V6 short block dissembled-year and CID unknown
More Misc. boxes of ’68 CJ parts, brackets, etc, etc, etc!
Many boxes of Jeep and 4-Wheel Drive magazines
ALL MUST GO! Call Jeff for prices 425-334-8281 (after 4 pm)
Buick 225 V6 with wide ratio T-19 (6.32=1 first gear) and Scout 300 TC
New bearings and seals in Trans and TC
New clutch, throw-out bearing.
Fly wheel resurfaced
Hydraulic clutch (all together and ready to go)
Dana 44 high pinion front differential 5:38 gears
ARB locker
Warn axle shafts and 2 spare 19 spline hubs and dial
New bearings, gears, locker, spindles, Warn hubs. 5 on 5-1/2 never been run
Dana 60 low pinion rear differential 5:38 gears
Detriot locker
35 spline flanged axles, new gears, etc. (never been run)
5 on 5-1/2 bolt pattern (needs brakes.) Both diffs are 58” wide
Floor pan replaced in tub
Custom frame 2x4x1/4 wall tubing (made to factory dimensions)
Misc. Parts:
T-19 close ratio trans. 4:1 first gear with Dana 18 TC and Warn OD
5 quanity Super Swamper TSL bias ply 36x12-1/2x15 tires mounted on steel wheels
Rubicon Express ¼ elliptical rear springs
Rubicon Express spring over springs (both new)
MTS under seat plastic fuel tank
Borgenson steering shaft, tilt steering column
Offset ’70-’71 Dana 44 rear differential housing with 30 spline flanged axles have 5:38 RP and carrier. New brakes
Warn full float kits for offset 44 complete with lock-out hubs and spare 30 spline hub
Standard rear seat (black)
’75 CJ gas tank
Rear tire carrier and Jerry can holder
2 quanity ’68 CJ5 heater assemblies. One works, the other one might?
Mechanical gauges (oil, water, temp, vacuum, gas, volts speedo, tach. SW, VDO, and autometer)
York AC compressor
Warn 8274 winch
Wind shield frame (glass good, wipers work, frame is rusty)
2 quanity tailgates
4 quanity 15x10 aluminum rims 3-1/4 back spacing
’68 Grille (good shape with lights and Rad)
’74 Grille (good shape)
Bikini top and half doors
2 quanity full doors
6-point roll cage and competition seat belts 3” wide
Buick V6 short block dissembled-year and CID unknown
More Misc. boxes of ’68 CJ parts, brackets, etc, etc, etc!
Many boxes of Jeep and 4-Wheel Drive magazines
ALL MUST GO! Call Jeff for prices 425-334-8281 (after 4 pm)