fird rear dana 60

[4xrick]

out of an older ford. 10 spline axles and 4:10 gears. not sure much about these axles being that im a chevy guy and its out of a ford. it is not ful size but out of an older ford that in a little narrower. I can get wms if needed. asking $100 obo

[Csnyder]

I'm interested. Can you let me know the WMS width and tube diameter?

Thanks,
- Chris

[4xrick]

it looks like its about 63 1/2 inches wms but i couldnt get an exzact measurement alone. the axle tube is 3 inches around.

[Junkyard Jim]

10 or 19 spline?

[4xrick]

10 spline axles and 4:10 gears. 10 spline :D

[Csnyder]

it looks like its about 63 1/2 inches wms but i couldnt get an exzact measurement alone. the axle tube is 3 inches around.

Full float I'm assuming? If so, probably too narrow for me to cut the full float shiat off and go semi float, as I intend to when I build my rear 60 next year. :(

- Chris

[4xrick]

honestly i dont know if it is full or semi. like I said before i am a chevy guy and dont know much about ford axles. i just know that i want it out of my garage and need to at least break even on the deal. what wms are you looking for?

[GEARHEAD]

Full float means its like your 14 bolt as in you can unbolt the axles without removing the wheels. Semi-float meaning like your 12-10 bolts the weight of the truck is on the shafts.....I'm going to guess it is a full float.

[4xrick]

it is a ff. sorry I havnt even looked at it to check if it was on not. lol so aaron what about you coming over and trying to find the numbers on this thing so i can give you something out of it?

[Csnyder]

honestly i dont know if it is full or semi. like I said before i am a chevy guy and dont know much about ford axles. i just know that i want it out of my garage and need to at least break even on the deal. what wms are you looking for?

When it's finished, I'm aiming for either 62" if I keep my D44 front, or 64" if I sell the front 44 and build a 60. Still haven't made up my mind yet... well, at least my wallet hasn't made up it's mind. ;) So, to be on the safe side, I need roughly 61" of raw tube width w/ the center section.

- Chris

[4xrick]

ttt need to be gone. will take $75

[Boonie Buster]

lug pattern? maybe interested...... :hmmm:

[4xrick]

it is 8 lug

[4xrick]

did i mention its obo?

[4xrick]

ttt

[4xrick]

$50 this thing needs to get out of my garage.

[4xrick]

someone has gotta have a use for this thing.

[dozereng]

PM Sent

[4xrick]

i sent you back a pm and also called yet never heard anything back
anyone else?